Home & Brewing RTD Pt100 Temperature Sensor 1.5" TC(50.5mm OD) by 3"(73.5mm) Length with Detachable Connector Electric Homebrew Rims Tube Parts Brewing Accessories

RTD Pt100 Temperature Sensor 1.5"TC by 3"L Probe with Detachable ConnectorThis high-temperatre PT100 SENSOR is equipped with an 1.5"TC by 3"(73.5mm) stainless steel shield is good for 500.Features:1. Based on resistance measurement principles.2. Resistor material is Platinum with a value of 100 ohm at temperature 0.3. Platinum has a positive resistance temperature factor, resistance increases with rising temperature.4. Each sensor comes with three wires. Two of the wires connect to either side of the platinum resistor like you'd expect. The third wire is also connected to one end of the PT100. If your RTD amplifier supports 3-wire sensors, it will drive the resistor with the first two wires, and measure the voltate differences so that it can subtract any voltage drop from the wire. If your RTD amplifier only has 2-wire support simpl leave the third wire disconnected.5. 1.5"TC(50.5mm) by 3"(73.5mm)long stainless steel tube, contain a PT100 temperature sensor.6. Cable is approx 2 m / 200 cm long, three wires with detachable connector.7. Usable Temperature Range: -200 to 550 (-328 to 1,022)==========Material : Stainless Steel**Purchase Notes***Because it is manual measurement, please allow 1-3% error and make sure not to mind ordering.*Product photos are taken in kind, because the light is different from the display, so the color may be different. The product will be subject to the actual product received.

• RTD Pt100 Temperature Sensor 1.5"TC by 3"L Probe with Detachable Connector
• This high-temperatre PT100 SENSOR is equipped with an 1.5"TC by 3"(73.5mm) stainless steel shield is good for 500.
• 5. 1.5"TC(50.5mm) by 3"(73.5mm)long stainless steel tube, contain a PT100 temperature sensor.
• 6. Cable is approx 2 m / 200 cm long, three wires with detachable connector.
• 7. Usable Temperature Range: -200 to 550 (-328 to 1,022)